請問在GS/CE等認證中的電壓殘留測試的具體要求是怎樣的?
請問在GS/CE等認證中的電壓殘留測試的具體要求是怎樣的?我記得是拔插頭后1秒鐘內,電容兩端電壓必須降到安全電壓以下45V還是36,不記得了.
全部回復(1)
正序查看
倒序查看
終于打到了,大抄下來大家分享:
60335-1的22.5條
34V
22.5 Appliances intended to be connected to the supply mains by means of a plug shall be
constructed so that in normal use there is no risk of electric shock from charged capacitors
when the pins of the plug are touched.
NOTE Capacitors having a rated capacitance up to 0,1 μF are not considered to entail a risk of electric shock.
Compliance is checked by the following test.
The appliance is supplied at rated voltage. Any switch is then placed in the off position and
the appliance is disconnected from the supply mains at the instant of voltage peak. One
second after disconnection, the voltage between the pins of the plug is measured with an
instrument that does not appreciably affect the value to be measured.
The voltage shall not exceed 34 V.
60335-1的22.5條
34V
22.5 Appliances intended to be connected to the supply mains by means of a plug shall be
constructed so that in normal use there is no risk of electric shock from charged capacitors
when the pins of the plug are touched.
NOTE Capacitors having a rated capacitance up to 0,1 μF are not considered to entail a risk of electric shock.
Compliance is checked by the following test.
The appliance is supplied at rated voltage. Any switch is then placed in the off position and
the appliance is disconnected from the supply mains at the instant of voltage peak. One
second after disconnection, the voltage between the pins of the plug is measured with an
instrument that does not appreciably affect the value to be measured.
The voltage shall not exceed 34 V.
0
回復
工程師都在看
