我用ATMEGA48v , ICC-AVR寫了這樣一段程序, IO 不允許中斷功能,全部 初始
為輸出電平!  定時器,AD,看門狗全部禁止(燒錄FUSE選項時也有禁止); 然后寫掉電模式指令后, 燒錄程序到MCU后, MCU不能進入掉電模式, 仍然以200MS 周期復位一次(非喚醒, 如果是正常喚醒LEDE會翻轉,但LEDE一直為熄滅狀態(tài)), LEDF 指示燈 不停 翻轉; 而用AVRSTUDIO軟件模擬時卻沒有這個問題.

請教一下 這是怎么引起的. 哪位兄弟能不能提供一個可以進入掉電模式的程序段給我學習一下． 謝謝!!


void port_init(void)
{
PORTB = 0x00;
DDRB  = 0xFF;
PORTC = 0x00; //m103 output only
DDRC  = 0x7F;
PORTD = 0x00;
DDRD  = 0xFF;
}

//call this routine to initialize all peripherals
void init_devices(void)
{
//stop errant interrupts until set up
CLI(); //disable all interrupts
port_init();

MCUCR = 0x00;
EICRA = 0x00; //extended ext ints
EIMSK = 0x00;

TIMSK0 = 0x00; //timer 0 interrupt sources
TIMSK1 = 0x00; //timer 1 interrupt sources
TIMSK2 = 0x00; //timer 2 interrupt sources

PCMSK0 = 0x00; //pin change mask 0
PCMSK1 = 0x00; //pin change mask 1
PCMSK2 = 0x00; //pin change mask 2
PCICR = 0x00; //pin change enable
PRR = 0xFF; //power controller
SEI(); //re-enable interrupts
//all peripherals are now initialized
}
//＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝
main()
{
   if(i!=0x55)
     { init_devices();
     }
     i = 0x55 ;
     watchdog_init();
CLI();
ADCSRA = 0x00;
EIMSK = 0x00;  //外部中斷X允許
EIMSK=0X00;
     PCIFR = 0X07; //清中斷符

WDR();
WDTCSR |= (1< WDTCSR=0X00;


PRR=0XfF;
SMCR=0X05;

waitsleep:
PORTB^=(1< asm ("sleep");
PORTD^=(1< goto waitsleep;

    SMCR&=~(1<    SMCR&=~(1<